EV Charger Installation Moorooka

Moorooka notes

Beaudesert Road is Moorooka's main street, with a busy strip of shops and restaurants, and Moorooka station on the Beenleigh line is a short walk from many homes. With the city about 7 km north, plenty of residents do short trips and could easily get by with a charge every few days.

Character homes here often have narrow side access, so a car parked at the back means a longer cable along the house. We route it in conduit along the wall or under the floor. Some streets have heritage or character controls that limit what can be fixed to the front of a house; a charger at the side or under the house usually avoids that. See switchboard upgrades if your board is original.

Charging under a Moorooka house

Much of Moorooka was built in the 1940s and 1950s, with post-war timber homes raised on stumps on quarter-acre blocks. Many have been lifted, enclosed underneath or extended. Where the car lives under the house, the wallbox goes on a stump or wall right beside it, and the cable drops down from the switchboard with very little fuss. Enclosed lower levels need a little more planning, since the cable may have to pass through a new wall.

The switchboard decides most of the cost. Moorooka homes range from untouched originals to full renovations. An original board with fuses and no safety switches needs replacing first; a recently upgraded one may just need a breaker and RCD added.

If you are planning a renovation, tell us early. A charger circuit added while the walls are open, or while the board is being replaced anyway, costs less than retrofitting it later.

How much does EV charger installation cost in Moorooka?

A standard single-phase EV charger installation in Moorooka costs from $990 inc GST with Connex Electrical, plus the charger if you need one. Most Moorooka houses pay just that. The price only rises for a long cable run, an older switchboard that needs upgrading, or a three-phase charger, and you see any extra in a fixed written quote first.

The standard price covers a dedicated circuit with RCD protection, a standard cable run, mounting, charger setup, testing and your Certificate of Testing and Compliance. The charger itself is extra unless you already own one.

Keeping your Moorooka install affordable

• Send clear photos of the switchboard and charger spot, so we can quote without a site visit.
• If a second EV is coming, size the cable for it now rather than paying for a second callout later.
• Charge overnight on an off-peak tariff, or from surplus solar, to keep running costs low.
• Already have a charger from the dealer? We install it, so you only pay for installation.

Moorooka is about 33 km from Mango Hill, roughly 35 minutes depending on how the Gateway and inner southside roads are flowing. We send an arrival window the day before the job.

Every Moorooka job gets a fixed written price before any work starts, so the quote is what you pay. For a line-by-line breakdown, see the EV charger installation cost guide for Brisbane, or call 0474 207 609.

From quote to first charge

1. Step 1

   Quote

   Send photos of your switchboard and charger spot, or call. We reply with a fixed written price.

2. Step 2

   Site check

   If anything is unusual, such as a long run or an older board, we check it in person first.

3. Step 3

   Install

   Most standard installs take 2 to 4 hours on the day.

4. Step 4

   Test and certify

   We test, commission the charger with your car and issue your Certificate of Testing and Compliance.

Nearby suburbs we also cover

• Yeerongpilly
• Salisbury
• Tarragindi
• Annerley
• Yeronga
• Tennyson

See every suburb in Southside, or read about home EV charger installation, commercial and body corporate charging and the cost of installation in Brisbane.