EV Charger Installation Inala

Fibro walls, older boards and other Inala details

Fibro cement sheeting on homes of this age can contain asbestos. We treat it with care: we avoid drilling or cutting suspect sheeting where possible, route cable through other surfaces or use surface-mounted fixings, and tell you up front if testing is needed. It is rarely a barrier to installing a charger, but it does shape where the charger goes.

Many Inala homes have been sold out of public housing into private hands, and renovation styles vary from street to street. If your home has had its electrics redone, the job can be as simple as one in a new estate. Read about switchboard upgrades for EV chargers if yours has not.

Putting a charger on an Inala house

Inala was laid out as a large Queensland Housing Commission estate from the 1950s, and many of its homes are lowset timber or fibro houses on generous blocks. Some have been extended, rewired or rebuilt over the years; others still have much of their original wiring. That is why an Inala quote starts with photos of the switchboard and meter box. An older board with ceramic fuses or no safety switches needs upgrading before a charger can go in.

Plenty of these homes have no garage, just a carport or a driveway beside the house. That is fine: most wallboxes are rated for outdoor use, and we can mount one on the carport post or the house wall where the cable reaches the car without crossing a path.

The big lots help. There is usually room to put the charger exactly where you park, and the run from the meter is rarely complicated.

EV charger installation cost in Inala

Expect to pay from $990 inc GST for a standard single-phase charger install in Inala, plus the charger itself. That is the price for most garages and carports. Long runs, switchboard upgrades and three-phase chargers are the only common extras, and Connex Electrical quotes them in writing before you book.

Included as standard: a new charger circuit and protection at your switchboard, cabling within the standard allowance, mounting, app setup, testing and a compliance certificate. The charger itself is extra unless you already own one.

Keeping your Inala install affordable

• If a second EV is coming, size the cable for it now rather than paying for a second callout later.
• Charge overnight on an off-peak tariff, or from surplus solar, to keep running costs low.
• Send clear photos of the switchboard and charger spot, so we can quote without a site visit.
• Mount the charger on the garage wall closest to the meter box. A shorter run is the easiest saving.

Inala is around 39 km from Mango Hill, roughly 45 minutes depending on the motorway traffic. We can quote from photos first, so a visit is only needed when the board or wall material calls for a closer look.

Every Inala job gets a fixed written price before any work starts, so the quote is what you pay. For a line-by-line breakdown, see the EV charger installation cost guide for Brisbane, or call 0474 207 609.

From quote to first charge

1. Step 1

   Request a quote

   Use the form or call us. Photos of the meter box and garage speed things up.

2. Step 2

   We confirm the details

   Supply capacity, cable route and any Energex requirements are checked before we book.

3. Step 3

   We install

   Circuit, protection and charger, usually done in 2 to 4 hours.

4. Step 4

   You start charging

   We commission the charger with your car and leave you with your Certificate of Testing and Compliance.

Nearby suburbs we also cover

• Durack
• Richlands
• Willawong
• Darra
• Doolandella
• Forest Lake

See every suburb in Southside, or read about home EV charger installation, commercial and body corporate charging and the cost of installation in Brisbane.