EV Charger Installation Algester

When the garage is no longer a garage

Converting the original single garage into a bedroom or rumpus room was a popular renovation in houses of this era, and Algester has its share. If your car now parks on the driveway or under a carport added later, the charger needs to go outside. That is fine, as long as the unit is rated for the weather and mounted where rain, sun and the cable are all accounted for.

On a brick wall facing the driveway, we mount the charger at a comfortable height with a holster so the cable stays off the ground. If the nearest wall is too far from where you park, a pedestal mount on a concrete footing is the other option. Cable runs from the meter box usually go through the roof space and down the outside wall in conduit.

Most homes here are single phase, and a 7kW charger is all most drivers need.

Algester boards and homes

Switchboards in 1980s homes often have a couple of safety switches but leave some circuits unprotected, and some still use rewireable fuses. Meter boards installed before the late 1980s may also contain asbestos. We check both and quote any upgrade separately before the charger goes in.

The suburb sits between Acacia Ridge and Sunnybank Hills, with good access to the main roads heading north. For daily commutes and errands, an overnight 7kW charge is more than enough, and a driveway charger can be scheduled to start once the evening peak has passed.

If you are thinking about which charger to choose for an outdoor wall, our charger brands guide covers weather ratings and tethered versus untethered models.

EV charger installation cost in Algester

Expect to pay from $990 inc GST for a standard single-phase charger install in Algester, plus the charger itself. That is the price for most garages and carports. Long runs, switchboard upgrades and three-phase chargers are the only common extras, and Connex Electrical quotes them in writing before you book.

Every standard install includes its own circuit and safety switch protection, the cable run within the standard length, mounting and setup, full testing and a Certificate of Testing and Compliance. The charger itself is extra unless you already own one.

How to pay less for a charger in Algester

• Charge overnight on an off-peak tariff, or from surplus solar, to keep running costs low.
• Choose a 7kW single-phase charger. It suits almost every household and avoids three-phase costs.
• Already have a charger from the dealer? We install it, so you only pay for installation.
• If a second EV is coming, size the cable for it now rather than paying for a second callout later.

Algester is about 42 km from our Mango Hill base, roughly 45 minutes via the Gateway Motorway, and we book southside installs with a confirmed start time.

Every Algester job gets a fixed written price before any work starts, so the quote is what you pay. For a line-by-line breakdown, see the EV charger installation cost guide for Brisbane, or call 0474 207 609.

How it works

1. Step 1

   Quote

   Send photos of your switchboard and charger spot, or call. We reply with a fixed written price.

2. Step 2

   Site check

   If anything is unusual, such as a long run or an older board, we check it in person first.

3. Step 3

   Install

   Most standard installs take 2 to 4 hours on the day.

4. Step 4

   Test and certify

   We test, commission the charger with your car and issue your Certificate of Testing and Compliance.

Suburbs close to Algester

• Pallara
• Sunnybank Hills
• Calamvale
• Parkinson
• Acacia Ridge
• Willawong

See every suburb in Southside, or read about home EV charger installation, commercial and body corporate charging and the cost of installation in Brisbane.